PLANET XGS3-24040 - Manual (Page 716)

XGS3 Command Guide
39-48
Function: Configure the interface’s sending interval of querying specific group. The “no ipv6 mld
last-member-query-interval” command cancels the manually configured value and restores the default
value.
Parameter: is the interval of querying specific group, it ranges from 1000 to 25500ms. It’s the
integer times of 1000ms. If it’s not the integer times of 1000ms, the system will convert it to the integer
times of 1000ms.
Default: 1000ms.
Command Mode: Interface Configuration Mode
Example: Configure the interface vlan1’s MLD last-member-query-interval as 2000.
Router(config)#int vlan 1
Router(Config-if-vlan1)#ipv6 mld last-member-query-interval 2000
39.7.9 ipv6 mld limit
Command:ipv6 mld limit <state-count>
no ipv6 mld limit
Function: Configure the MLD state count limit of the interface; the “no ipv6 mld limit” command
restores the manually configured value to default value.
Parameter: <state-count>:max MLD state the interface maintains, the valid range is 1-5000.
Default: 400 by default
Command Mode: Interface Configuration Mode
Usage Guide: When max state-count is configured, the number of the state the interface saves will only
upper to the state-count limit; and when the max state-count is reached, the later new member
qualification report received will be ignored. If some MLD group state has already been saved before this
command configured, the original states will be removed and the MLD general query will be sent to
collect group member qualification reports no more than the max state-count.
Example: Set the MLD state-count limit of the interface vlan2 to 4000.
Switch(config)#interface vlan2
Switch(Config-if-Vlan2)#ipv6 mld limit 4000
39.7.10 ipv6 mld query-interval
Command: ipv6 mld query-interval <time_val>
no ipv6 mld query-interval
Function: Configure the interval of the periodically sent MLD host-query messages; the “no ipv6 mld
query-interval” command restores the default value.
Parameter: <time_val> is the interval of the periodically sent MLD host-query messages; it ranges from
0 to 65535s
Default: Intrerval of periodically transmitted MLD query message is 125s.
Command Mode: Interface Configuration Mode
Usage Guide: When a interface enables a kind of multicast protocol, it will send MLD host-query
messages periodically. This command is used to configure the query period.