PLANET XGS3-24040 - Manual (Page 438)

32-151
Default:
Close the debug by default.
Command Mode:
Admin Mode.
Usage Guide:
None.
Example:
Switch# debug ipv6 rip redistribute message send
Switch# no debug ipv6 rip redistribute message send
32.8 debug ipv6 rip redistribute route receive
Command:
debug ipv6 rip redistribute route receive
no debug ipv6 rip redistribute route receive
Function:
To enable the debugging switch received from NSM for redistribution of routing information for
RIPng. The no form of this command will disable the debugging switch.
Parameter:
None.
Default:
Close the debug by default.
Command Mode:
Admin Mode.
Usage Guide:
None.
Example:
Switch#debug ipv6 rip redistribute route receive
Switch# no debug ipv6 rip redistribute route receive
32.9 ipv6 rip aggregate-address
Command:
ipv6 rip aggregate-address X:X::X:X/M
no ipv6 rip aggregate-address X:X::X:X/M
Function:
To configure IPv6 aggregation route. The no form of this command deletes the IPv6 aggregation
route.
Parameter:
X:X::X:X/M: IPv6 address and prefix length.