PLANET XGS3-24040 - Manual (Page 818)

55-4
Usage Guide: This command is used to create or delete a VRRPv3 virtual router. The virtual router is
uniquely specified by the virtual router ID and the related virtual IPv6 address. Only after creating a virtual
router, relative configuration can be set on it. Considering the stability, the number of configurable virtual
routers should not be more than 64.
Example: Configure a virtual router whose ID is10.
Switch(config)# router ipv6 vrrp 10
55.9 show ipv6 vrrp
Command: show ipv6 vrrp [<vrid>]
Function: Display the state and configuration information of VRRPv3 backup group.
Parameters: is the ID of the virtual router, whose range is from 1 to 255, no parameter means to
display the state and configuration infomation of all backup gorups.
Command Mode: Admin and Configuration Mode.
Example:
Switch# show ipv6 vrrp
VrId 1
State is Master
Virtual IPv6 is fe80::2 (Not IPv6 owner)
Interface is Vlan1
Configured priority is 150, Current priority is 150
Advertisement interval is 100 centisec
Preempt mode is TRUE
Circuit failover interface Vlan1, Priority Delta 3, Status UP
VrId 10
State is Initialize
Virtual IPv6 is fe80::3 (Not IPv6 owner)
Interface is Vlan2
Priority is 100
Advertisement interval is 300 centisec
Preempt mode is TRUE
Circuit failover interface Vlan2, Priority Delta 10, Status UP
Display
Explanation
State
State.
Virtual IPv6
Virtual IPv6 address.
Interface