PLANET XGS3-24040 - Manual (Page 128)

XGS3 Command Guide
7-128
6.6 debug loopback-detection
Command:
debug loopback-detection
Function:
After enabling the loopback detection debug on a port, BEBUG information will be generated when sending,
receiving messages and changing states.
Parameters:
None.
Command Mode:
Admin Mode.
Default:
Disabled by default.
Usage Guide:
Display the message sending, receiving and state changes with this command.
Example:
Switch#debug loopback-detection
%Jan 01 03:29:18 2006 Send loopback detection probe packet:dev Ethernet1/10, vlan id 1
%Jan 01 03:29:18 2006 Send loopback detection probe packet:dev Ethernet 1/10, vlan id 2
Chapter 7 Commands for ULDP
7.1 uldp enable
Command:
uldp enable
Function:
ULDP will be enabled after issuing this command. In global configuration mode, this command will enable ULDP for
the global. In port configuration mode, this command will enable ULDP for the port.
Parameters:
None.
Command Mode:
Global Configuration Mode and Port Configuration Mode.
Default:
By default ULDP is not configured.
Usage Guide:
ULDP can be configured for the ports only if ULDP is enabled globally. If ULDP is enabled globally, it will be effect for
all the existing fiber ports. For copper ports and fiber ports which are available after ULDP is enabled, this command
should be issued in the port configuration mode to make ULDP be effect.
Example:
To enable ULDP in global configuration mode.
Switch(config)#uldp enable