PLANET XGS3-24040 - Manual (Page 525)

35-238
35.27 bgp scan-time
Command: bgp scan-time <0-60>
no bgp scan-time [<0-60>]
Function: Set the time interval of the periodical next-hop validation; the “no bgp scan-time [<0-60>]”
command restores to the default value.
Parameter: <0-60>: Validation time interval.
Default: Default interval is 60s.
Command Mode: BGP route mode
Usage Guide: Validate the next-hop of BGP route, this command is for configuring the interval of this
check. Set the parameter to 0 if you don’t want to check.
Example:
Switch(config-router)# bgp scan-time 30
35.28 clear ip bgp
Command: clear ip bgp [view ] {<*>|| external|peer-group |}
[] [in [prefix-filter] |out|soft [in|out]]
Function: Clear up BGP links or states.
Parameter: *: all.
: AS number.
: Respectively BGP instance name and peer group name.
: IP address.
: Address family, such as “ipv4 unicast”.
Default: None.
Command Mode: Admin mode
Usage Guide: Clearing up BGP state in different parameters (such as AS number, peer group name,
IPv4 address, address-family, external neighbor), or the inbound or outbound messages. Also it is
optional to use the saved ORF as soft reconfiguration, or use the soft in|out commands for in or out soft
reconfiguration if it is already set.
Example:
When soft reconfiguration is set, use this command for soft reconfiguration.
Switch# clear ip bgp * soft in
Will clear up all established connections.
Switch# clear ip bgp *