PLANET XGS3-24040 - Manual (Page 691)

XGS3 Command Guide
39-23
39.3.26 ipv6 pim register-suppression
Command: ipv6 pim register-suppression <value>
no ipv6 pim register-suppression
Function: This command is to configure the value of register suppression timer, the unit is second.
Parameter: <value> is the timer’s value, it ranges from 10 to 65535s.
Default: 60s
Command Mode: Global Mode
Usage Guide: If this value is configured at DR, it’s the value of register suppression timer; if this value is
configured at RP and ipv6 pim rp-register-kat is not used at RP, this command modifies Keepalive-period
value. The “no ipv6 pim register-suppression” command restores the default value.
Example: Configure the value of register suppression timer to 30s.
Switch(config)# ipv6 pim register-suppression 30
39.3.27 ipv6 pim rp-address
Command: ipv6 pim rp-address <rp-address> [<group-range>]
no ipv6 pim rp-address <rp-address> [all|<group-range>]
Function: This command is to configure static RP globally or in a multicast address range. The “no ipv6
pim rp-address” command cancels static RP.
Parameter: <rp-address> is the RP address, the format is X:X::X:X ,ipv6 address
<group-range> is the expected RP, the format is X:X::X:X/M, ipv6 address and prefix
length all the ranges
Default: This switch is not a RP static router
Command Mode: Global Mode
Usage Guide: This command is to configure static RP globally or in a multicast address range.
Example: Configure 2000:112::8 as RP address globally.
Switch (config)# ipv6 pim rp-address 2000:112::8 ff1e::/64
39.3.28 ipv6 pim rp-candidate
Command: ipv6 pim rp-candidate{vlan |loopback |}[]
[]
no ipv6 pim rp-candiate
Function: This command is the candidate RP global configure command, it is used to configure PIM-SM
candidate RP information in order to compete RP router with other candidate RPs. The “no ipv6 pim
rp-candiate” command cancels the candidate RP.
Parameter: is VLAN ID；
is Loopback interface index;
<ifname> is the name of the interface;
<group range> is the group range of the candidate RP,the format is X:X::X:X/M, ipv6
address and prefix length;
is the RP selection priority, ranges from 0 to 255, the default value is 192, the