PLANET XGS3-24040 - Manual (Page 708)

XGS3 Command Guide
39-40
39.6.4 ipv6 multicast destination-control access-group
(sip)
Command: ipv6 multicast destination-control > access-group <9000-10999>
no ipv6 multicast destination-control access-group <9000-10999>
Function: Configure multicast destination-control access-list used on specified net segment, the “no
ipv6 multicast destination-control <IPADDRESS/M> access-group <9000-10999>“command deletes
this configuration.
Parameter: <IPADDRESS/M>: IP address and mask length;
<9000-10999>: Destination control access-list number.
Default: None.
Command Mode: Global Mode.
Usage Guide: The command is only working under global IPv6 multicast destination-control enabled,
after configuring the command, if MLD-SPOOPING or MLD is enabled, for adding the members to
multicast group. If configuring multicast destination-control on specified net segment of transmitted
MLD-REPORT, and match configured access-list, such as matching permit, the interface can be added,
otherwise do not be added. If relevant group or source in show ipv6 mld groups detail has been
established before executing the command, it needs to execute clear ipv6 mld group command to clear
relevant groups in admin mode.
Example:
Switch(config)#ipv6 multicast destination-control 2008::8/64 access-group 9000
39.6.5 ipv6 multicast destination-control access-group
(vmac)
Command: ipv6 multicast destination-control <1-4094> access-group <9000-10999>
no ipv6 multicast destination-control <1-4094> > access-group
<9000-10999>
Function: Configure the IPv6 multicast destination access list used by the specified vlan-mac, the no
operation of this command will delete this configuration.
Parameters: <1-4094>: VLAN-ID;
: The source MAC address sending of the MLD-REPORT, the format of which
is“xx-xx-xx-xx-xx-xx”.
<9000-10999>: Destination access list number.
Default: Not configured.
Command Mode: Global Configuration Mode.
Usage Guide: This command can only take effect when the IPv6 multicast destination control is globally
enabled, after configuring this command, if the MLD-SNOOPING is enabled, when adding the port to the
multicast group, it will be matched according to the configured access list. Only when the port is matched
as permit, will it be added, or it can not be added.