PLANET XGS3-24040 - Manual (Page 632)

XGS3 Command Guide
38-61
38.7.8 show ip dvmrp
Command: show ip dvmrp
Function: Display DVMRP protocol information.
Parameter: None
Default: Do not display (Off)
Command Mode: Any Configuration Mode
Usage Guide: The command applies to display some total statistic information of DVMRP protocol
Example:
Switch#show ip dvmrp
DVMRP Daemon Start Time: MON JAN 01 00:00:09 2001
DVMRP Daemon Uptime: 17:37:03
DVMRP Number of Route Entries: 2
DVMRP Number of Reachable Route Entries: 2
DVMRP Number of Prune Entries: 1
DVMRP Route Report Timer: Running
DVMRP Route Report Timer Last Update: 00:00:56
DVMRP Route Report Timer Next Update: 00:00:04
DVMRP Flash Route Update Timer: Not Running
38.7.9 show ip dvmrp interface
Command: show ip dvmrp interface [<ifname>]
Function: Display DVMRP interface
Parameter: is interface name, namely displaying configured interface information of specified
interface.
Default: Do not display (Off)
Command Mode: Any Configuration Mode
Example:
Switch #show ip dvmrp in vlan4
Address Interface Vif Ver. Nbr Type Remote
Index Cnt Address
13.1.1.3 Vlan1 1 v3.ff 0 BCAST N/A
10.1.35.3 Vlan2 0 v3.ff 0 BCAST N/A
Switch #
Displayed Information
Explanations