PLANET XGS3-24040 - Manual (Page 156)

11-22
Usage Guide:
When GARP application entities receive a join message, join message will not be sent immediately.
Instead, hold timer is started. After hold timer timeout, all join messages received with the hold time
will be sent in one GVRP frame, thus effectively reducing protocol message traffic.
Example:
Set the GARP hold timer value of port 1/10 to 500 ms.
Switch(Config-If-Ethernet1/10)#garp timer hold 500
11.1.6 garp timer join
Command:
garp timer join <timer-value>
no garp timer join
Function:
Set the join timer for GARP; the “no garp timer join” command restores the default timer setting.
Parameter:
is the value for join timer, the valid range is 100 to 327650 ms.
Command mode:
Port Mode.
Default:
The default value for join timer is 200 ms.
Usage Guide:
GARP application entity sends a join message after join timer over, other GARP application entities
received the join message will register this message.
Example:
Set the GARP join timer value of port 10 to 1000 ms.
Switch(Config-If-Ethernet1/10)#garp timer join 1000
11.1.7 garp timer leave
Command:
garp timer leave <timer-value>
no garp timer leave
Function:
Set the leave timer for GARP; the “no garp timer leave” command restores the default timer
setting.
Parameter:
is the value for leave timer, the valid range is 100 to 327650 ms.
Command mode:
Port Mode.
Default:
The default value for leave timer is 600 ms.
Usage Guide: