PLANET XGS3-24040 - Manual (Page 436)

32-149
is the local link address or its prefix.
specifies the access-list number or name applied.
Default:
The default managing distance of RIP is 120.
Command Mode:
Router mode and address-family mode.
Usage Guide:
In case there are routes from two different routing protocols to the same destination, the managing
distance is then used for selecting routes. The less the managing distance of the route protocol is ,
the more reliable will be the route acquired from the protocol.
Example:
Switch#config terminal
Switch(config)#router rip
Switch(config-router)#distance 8 fe80:1111::4200:21ff:fe00:11 mylist
32.5 distribute-list
Command:
distribute-list {access-list-name> |prefix<prefix-list-name>} {in|out} [>|vlan
]
no distribute-list {access-list-name> |prefix<prefix-list-name>} {in|out} [>|vlan
]
Function:
This command uses access-list or prefix-list to filter the route renews messages sent and received.
The “no distribute-list {access-list-name> |prefix<prefix-list-name>} {in|out} [>|vlan
]” command cancels this filter function.
Parameter:
is the name or access-list number to be applied.
is the name of the prefix-list to be applied.
specifies the name of interface to be applied with route filtering.
Default:
Function disabled by RIPng by default.
Command Mode:
Router mode
Usage Guide:
The filter will be applied to all interfaces if no specific interface is set.
Example:
Switch#config terminal
Switch(config)#router ipv6 rip