PLANET XGS3-24040 - Manual (Page 829)

Commands for Reliability Chapter 4 Commands for ULPP
57-4
57.9 flush disable mac
Command: flush disable mac
Function: Disable sending the flush packets of updating MAC address.
Parameter: None.
Default: By default, enable sending the flush packets of updating MAC address.
Command mode: ULPP group configuration mode.
Usage Guide: If configure this command, when the link is switched, it will not actively send the flush
packets to notify the upstream device to update the MAC address table.
Example: Disable sending the flush packets of updating MAC address.
Switch(config)# ulpp group 20
Switch(ulpp-group-20)# flush disable mac
57.10 flush enable arp
Command: flush enable arp
Function: Enable sending the flush packets of deleting ARP.
Parameter: None.
Default: By default, enable sending the flush packets of deleting ARP.
Command mode: ULPP group configuration mode.
Usage Guide: If enable this function, when the link is switched, it will actively send the flush packets to
notify the upstream device, so as to delete the list entries of ARP.
Example: Enable sending the flush packets of deleting ARP.
Switch(config)# ulpp group 20
Switch(ulpp-group-20)# flush enable arp
57.11 flush enable mac
Command: flush enable mac
Function: Enable sending the flush packets of updating MAC address.
Parameter: None.
Default: By default, enable sending the flush packets of updating MAC address.
Command mode: ULPP group configuration mode.
Usage Guide: If enable this function, when the link is switched, it will actively send the flush packets to
notify the upstream device, so as to update the MAC address table.
Example: Enable sending the flush packets of updating MAC address.
Switch(config)# ulpp group 20
Switch(ulpp-group-20)# flush enable mac