PLANET XGS3-24040 - Manual (Page 718)

XGS3 Command Guide
39-50
39.7.13 ipv6 mld static-group
Command: ipv6 mld static-group [source ]
no ipv6 mld static-group [source ]
Function: Configure certain static group or static source on the interface. The “no” form of this command
cancels certain previously configured static group or static source.
Parameter: is a valid IPv6 multicast address; is a valid IPv6 unicast
address.
Default: No static group or static source is configured on the interface by factory default.
Command Mode: Interface Configuration Mode
Usage Guide: The valid range of the static group multicast address configured by the interface is the
dynamic multicast address specified by the IPv6 protocol. Once the interface configures static group or
static source for the multicast address, no matter whether there is membership qualification report of this
group or source in the subnet, MLD protocol will consider that the group or source exist. Note: the
configured static source is the source to be forwarded.
Example: Configure an MLD static-group ff1e::1:3 on interface vlan2.
Switch(Config-if-Vlan2)#ipv6 mld static-group ff1e::1:3 source 2001::1
Switch(config)#interface vlan 2
Switch(Config-if-Vlan2)#ipv6 mld static-group ff1e::1:3
Configure a static source 2001::1 of the group ff1e::1:3 on interface vlan2
Switch(config)#int vlan2
Switch(Config-if-Vlan2)#ipv6 mld static-group ff1e::1:3 source 2001::1
39.7.14 ipv6 mld version
Command: ipv6 mld version
no ipv6 mld version
Function: Configure the version of the MLD protocol running on the interface; the “no ipv6 mld version”
command restores the manually configured version to the default one.
Parameter: is the version number of the MLD protocol, with a valid range of 1-2.
Default: 2 by default
Command Mode: Interface Configuration Mode
Usage Guide: While there is routers still not upgraded to version 2 of MLD protocol on the subnet
connected, the interface should be configured to corresponding version.
Example: Configure the MLD version to 2.
Switch(config)#ipv6 mld version 2
Switch(config)#