PLANET XGS3-24040 - Manual (Page 243)

16-1
Chapter 16 Commands for Flow-based
Redirection
16.1 access-group redirect to interface ethernet
Command:
access-group <aclname> redirect to interface [ethernet <IFNAME> | <IFNAME>]
no access-group <aclname> redirect
Function:
Specify flow-based redirection; “no access-group redirect” command is used to delete
flow-based redirection.
Parameters:
<aclname> name of the flow , only supports digital standard IP ACL, digital extensive IP ACL,
nomenclatural standard IP ACL, nomenclatural extensive IP ACL, digital standard IPv6 ACL, and
nomenclatural standard IPv6 ACL. Parameters of Timerange and Portrange can not be set in ACL,
the type of ACL should be Permit. > the destination port of redirection.
Command Mode:
Physical Interface Configuration Mode.
Usage Guide:
“no access-group redirect” command is used to delete flow-based redirection.
Flow-based redirection function enables the switch to transmit the data frames meeting some
special condition to another specified port.
Examples:
Redirecting the frames whose source IP is 192.168.1.111 received from port 1 to port 6,
Switch(config)#access-list 1 permit host 192.168.1.111
Switch(config)# interface ethernet 1/1
Switch(Config-If-Ethernet1/1)# access-group 1 redirect to interface ethernet 1/6
16.2 show flow-based-redirect
Command:
show flow-based-redirect {interface [ethernet <IFNAME> | <IFNAME>]}
Function:
Display the information of current flow-based redirection in the system/port.
Parameters:
1. No specified port, display the information of all the flow-based redirection in the system.
2. Specify ports in , display the information of the flow-based redirection configured in
the ports listed in the interface-list.
Command Mode:
Admin Mode and Configuration Mode.