PLANET XGS3-24040 - Manual (Page 217)

14-83
Usage Guide:
Example:
Creating and then deleting a class map named “c1”.
Switch(config)#class-map c1
Switch(Config-ClassMap-c1)#exit
Switch(config)#no class-map c1
14.3 match
Command:
match {access-group <acl-index-or-name> | ip dscp <dscp-list> | ip precedence
<ip-precedence-list>| ipv6 access-group <acl-index-or-name> | ipv6 dscp <dscp-list> | ipv6
flowlabel <flowlabel-list> | vlan <vlan-list> | cos<cost-list>}
no match {access-group | ip dscp | ip precedence | ipv6 access-group | ipv6 dscp |
ipv6 flowlabel | vlan | cos }
Function:
Configure the match standard of the class map; the “no” form of this command deletes the specified
match standard.
Parameter:
access-group <acl-index-or-name> match specified IP ACL or MAC ACL, the parameters are the
number or name of the ACL;
ip dscp <dscp-list> and ipv6 dscp <dscp-list> match specified DSCP value, the parameter is a list
of DSCP consisting of maximum 8 DSCP values;
ip precedence <ip-precedence-list> match specified IP Precedence, the parameter is a IP
Precedence list consisting of maximum 8 IP Precedence values with a valid range of 0~7;
ipv6 access-group <acl-index-or-name> match specified IPv6 ACL, the parameter is the number
or name of the IPv6 ACL;
ipv6 flowlabel <flowlabel-list> match specified IPv6 flow label, the parameter is IPv6 flow label
value, the ranging is 0~1048575;
vlan <vlan-list> match specified VLAN ID, the parameter is a VLAN ID list consisting of maximum 8
VLAN IDs.
match specified CoS value, the parameter is a CoS list consisting of maximum 8 CoS.
Default:
No match standard by default
Command Mode:
Class-map Mode
Usage Guide:
Only one match standard can be configured in a class map. When configuring match the ACL, only
the permit rule is available in the ACL.