PLANET XGS3-24040 - Manual (Page 466)

33-179
Default:
Default OSPF cost on the interface is auto-figure out based bandwidth.
Command Mode:
Interface Configuration Mode.
Example:
Switch#config terminal
Switch(config)#interface vlan 1
Switch(Config-if-Vlan1)#ip ospf cost 3
33.28 ip ospf database-filter
Command:
ip ospf [<ip-address>] database-filter all out
no ip ospf [<ip-address>] database-filter
Function:
The command opens LSA database filter switch on specific interface; the “no ip ospf
[<ip-address>] database-filter” command closes the filter switch.
Parameter:
<ip-address> is the interface IP address shown in dotted decimal notation;
all: All LSAs.
out: Sent LSAs.
Default:
Filter switch Closed.
Command Mode:
Interface Configuration Mode.
Example:
Switch#config terminal
Switch(config)#interface vlan 1
Switch(Config-if-Vlan1)#ip ospf database-filter all out
33.29 ip ospf dead-interval
Command:
ip ospf [<ip-address>] dead-interval
no ip ospf [<ip-address>] dead-interval
Function:
Specify the dead interval for neighboring layer 3 switch; the “no ip ospf [<ip-address>]
dead-interval” command restores the default value.