PLANET XGS3-24040 - Manual (Page 610)

XGS3 Command Guide
38-39
Default: None.
Usage Guide: MSDP configuration mode can be returned to with the exit-peer-mode command, when
configuration to an MSDP Peer is done.
Example: Back to MSDP configuration mode from MSDP Peer configuration mode.
Switch(config-msdp-peer)# exit-peer-mode
38.4.20 mesh-group
Command: mesh-group <name>
no mesh-group <name>
Function: To configure MSDP Peer as specified mesh group number, if set the same MSDP Peer to
many mesh groups, then the last mesh group is available.
Parameter: name: Mesh-group name.
Command Mode: MSDP Peer Configuration Mode.
Default: MSDP Peer doesn’t belong to any mesh group by default.
Usage Guide: Mesh group can reduce SA message flooding and predigest Peer-RPF checking.
Example:
Switch(config)#router msdp
Switch(router-msdp)#peer 20.1.1.1
Switch(router-msdp-peer)# mesh-group PLANET-1
38.4.21 originating-rp
Command: originating-rp <interface-type>
no originating-rp
Function: Configure Originating RP address that to configure the IP address of the specified interface as
the IP address of the RP in the SA messages.
Parameter: <interface-type> < interface-number>: type and number of the port.
Command Mode: MSDP Configuration Mode and MSDP Peer Configuration Mode.
Default: The default RP address of SA message is the RP address of PIM configured.
Usage Guide: To configure the IP address of the specified interface as the IP address of the RP in the
SA messages. If no IP address is configured for the specified interface, or the interface is down, no SA
messages will be advertised. In this occasion, if multiple RP is configured for the device, other SA
messages for other RP will not be advertised either. Hence, it is required that the interface should be
working when being configured.
Example:
Switch(config)#router msdp
Switch(router-msdp)#originating-rp vlan 20