PLANET XGS3-24040 - Manual (Page 665)

XGS3 Command Guide
38-94
Usage Guide: The command configures the address filter for multicast group membership request. The
request for the specified address ranges will be dropped. This command is also available for both the
IGMP PROXY and PIM configuration. To be mentioned, this command cannot be applied with DVMRP
configuration.
Example: To enable SSM configuration on the switch, and specify the address in access-list 23 as the
filter address for SSM.
Switch(config)# access-list 23 permit host-source 224.1.1.1
Switch(config)#ip multicast ssm range 23
38.11.16 ip pim bsr-border
Command: ip pim bsr-border
no ip pim bsr-border
Function: To configure the PIM enabled port to consider all multicast source is directly connected; the no
form of this command will remove the configuration.
Command Mode: Interface Configuration Mode.
Default: Disabled.
Usage Guide: Configuring the multicast source to be considered as directly connected for the PIM
enabled port is used to determine the identity of DR and ORIGINATOR.
Example: To configure PIM enabled VLAN 2 as the port for BSR BORDER. For all the multicast flow
from external network through VLAN 2, the switch will consider the multicast source is directly connected
to the switch.
Switch(config)#interface vlan 2
Switch(Config-if-Vlan2)#ip pim bsr-border
38.11.17 show debugging igmp proxy
Command: show debugging igmp proxy
Function: Display the status of debug switch of IGMP Proxy.
Command Mode: Admin Mode.
Usage Guide: The debuging switch status of IGMP Proxy.
Example:
Switch(config)#show debugging igmp proxy
IGMP PROXY debugging status:
IGMP PROXY event debugging is on
IGMP PROXY packet debugging is on
IGMP PROXY timer debugging is on
IGMP PROXY mfc debugging is on