PLANET XGS3-24040 - Manual (Page 628)

XGS3 Command Guide
38-57
anycast-rp address:
The configured anycast-rp-address.
other rp unicast rp address:
The configured other RP communication addresses in accordance with the above anycast-rp-address.
other rp unicast rp address:
The configured other RP communication addresses in accordance with the above anycast-rp-address.
anycast-rp address:
The configured anycast-rp-address*.
other rp unicast rp address:
The configured other RP communication addresses in accordance with the above anycast-rp-address.
38.6 Commands for PIM-SSM
38.6.1 ip multicast ssm
Command: ip multicast ssm {default|range <access-list-number >}
no ip multicast ssm
Function: Configure the range of pim ssm multicast address. The “no ip multicast ssm” command
deletes configured pim ssm multicast group.
Parameter: default: indicates the default range of pim ssm multicast group is 232/8.
<access-list-number > is the applying access-list number, it ranges from 1 to 99.
Default: Do not configure the range of pim ssm group address.
Command Mode: Global Mode.
Usage Guide:
1. Only this command is configured, pim ssm can be available.
2. Before configuring this command, make sure ip pim multicasting succeed. This command can’t work
with DVMRP.
3. Access-list can’t used the lists created by ip access-list, but the lists created by access-list.
4. Users can execute this command first and then configure the corresponding acl; or delete
corresponding acl in the bondage. After the bondage, only command no ip pim ssm can release the
bondage.
5 .If ssm is needed, this command should be configured at the related edge route. For example, the local
switch with IGMP (must) and multicast source DR or RP (at least one of the two) configure this command,
the middle switch need only enable PIM-SM.
Example: Configure the switch to enable PIM-SSM, the group’s range is what is specified by access-list
23.
Switch (config)#ip multicast ssm range 23