PLANET XGS3-24040 - Manual (Page 760)

Commands for Security Function Chapter 2 Commands for 802.1x
42-32
Function: Sets the interval for the supplicant to re-transmit EAP request/identity frame; the “no dot1x
timeout tx-period” command restores the default setting.
Parameters: is the interval for re-transmission of EAP request frames, in seconds; the valid
range is 1 to 65535.
Command mode: Global Mode.
Default: The default value is 30 seconds.
Usage Guide: Default value is recommended.
Example: Setting the EAP request frame re-transmission interval to 1200 seconds.
Switch(config)#dot1x timeout tx-period 1200
42.23 dot1x unicast enable
Command: dot1x unicast enable
no dot1x unicast enable
Function: Enable the 802.1x unicast passthrough function of switch; the no operation of this command
will disable this function.
Command mode: Global Configuration Mode.
Default: The 802.1x unicast passthrough function is not enabled in global mode.
Usage Guide: The 802.1x unicast passthrough authentication for the switch must be enabled first to
enable the 802.1x unicast passthrough function, then the 802.1x function is configured.
Example: Enabling the 802.1x unicast passthrough function of the switch and enable the 802.1x for port
1/1.
Switch(config)#dot1x enable
Switch(config)# dot1x unicast enable
Switch(config)#interface ethernet 1/1
Switch(Config-If-Ethernet1/1)#dot1x enable
42.24 dot1x web authentication enable
Command: dot1x web authentication enable
no dot1x web authentication enable
Function: Enable Web authentication agent, the no command disable Web authentication agent.
Parameters: None.
Default: Web authentication agent is disabled.
Command mode: Global Mode.
Usage Guide: Dot1x function must be enabled before enabling Web authentication agent. When dot1x
web authentication agent is enabled, the dot1x privateclient enable command should not be
configured.
Example: Enable the Web authentication agent function.