PLANET XGS3-24040 - Manual (Page 533)

35-246
address-family is switched under address-family mode. If this option on any side between local side and
partner is not enabled, the address-family route will not be acquired by the partner even if the
corresponding address family routes acquired before will be cancelled after this option is disabled.
Example:
Switch(config-router)#neighbor 2002::2 activate
Switch(config-router)#address-family ipv4
Switch(config-router-af)#no neighbor 2002::2 activate
Switch(config-router-af)#
35.44 neighbor advertisement-interval
Command: neighbor {|} advertisement-interval <0-600>
no neighbor {|} advertisement-interval [<0-600>]
Function: Configure the update interval of specific neighbor route. The “no neighbor
{|} advertisement-interval [<0-600>]” command restores to default.
Parameter: : IP address of the neighbor.
: Name of the peer group.
<0-600>: Advertise interval, in seconds.
Default: Default IBGP is 5s, default EBGP is 30s.
Command Mode: BGP route mode and address-family mode
Usage Guide: Reduce this value will improve the route updating speed while also consumes more
bandwidth.
Example:
Switch(config-router)#neighbor 10.1.1.64 advertisement-interval 20
Switch(config-router)#no neighbor 10.1.1.64 advertisement-interval
Switch(config-router)#
35.45 neighbor allowas-in
Command: neighbor {|} allowas-in [<1-10>]
no neighbor {|} allowas-in
Function: Configure the counts same AS is allowed to appear in the neighbor route AS table. The “no
neighbor {|} allowas-in” restores to not allow any repeat.
Parameter: : IP address of the neighbor.
: Name of the peer group.
<1-10>: Allowed count of same AS number.
Default: In default conditions AS is not allowed repeating in the same route, and when set the repeat