PLANET XGS3-24040 - Manual (Page 814)

54-5
Displayed information
Explanation
State
Status
Virtual IP
Dummy IP address
Interface
Interface Name
Priority
Priority
Advertisement interval
Timer interval
Preempt
Preemptive mode
Circuit failover interface
Interface Monitor information
54.11 virtual-ip
Commands: virtual-ip <A.B.C.D>
no virtual-ip
Function: Configures the VRRP dummy IP address.
Parameters: <A.B.C.D> is the IP address in decimal format.
Default: Not configured by default.
Command mode: VRRP protocol configuration mode
Usage Guide: This command adds a dummy IP address to an existing Standby cluster. The "no
virtual-ip" command removes the dummy IP address from the specified Standby cluster. Each Standby
cluster can have only one dummy IP. VRRP priority as 255 (not configure), virtual-ip and interface ip
should in the same segment.
Special Notice: When updating to the newest version from 5.2.0.0 or an older one, the original VRRP
command configuration can’t be restored. Please delete the original configuration with “no router vrrp
”, and then reconfigure. Otherwise, problems like suspended tasks may happen.
Example: Setting the backup dummy IP address to 10.1.1.1.
Switch(Config-Router-Vrrp)# virtual-ip 10.1.1.1