PLANET XGS3-24040 - Manual (Page 132)

XGS3 Command Guide
7-132
Example:
To display the global ULDP information.
Switch(config)# show uldp
7.9 debug uldp fsm interface ethernet
Command:
debug uldp fsm interface ethernet >
no debug uldp fsm interface ethernet <IFname>
Function:
To enable debugging information for ULDP for the specified interface. The no form of this command will disable the
debugging information.
Parameters:
> is the interface name.
Command Mode:
Admin Configuration Mode.
Default:
Disabled by default.
Usage Guide:
This command can be used to display the information about state transitions of the specified interfaces.
Example:
Print the information about state transitions of interface ethernet 1/1.
Switch#debug uldp fsm interface ethernet 1/1
7.10 debug uldp error
Command:
debug uldp error
no debug uldp error
Function:
Enable the error message debug function, the no form command disable the function.
Parameter:
None.
Command Mode:
Admin Mode.
Default:
Disabled.
Usage Guide:
Use this command to display the error message.
Example:
Display the error message.
Switch#debug uldp error