PLANET XGS3-24040 - Manual (Page 444)

32-157
Switch(config)#router ipv6 rip
Switch(config-router)#route 3ffe:1234:5678::1/64
32.18 router ipv6 rip
Command:
router ipv6 rip
no router ipv6 rip
Function:
Enable RIPng routing process and entering RIPng mode; the “no router ipv6 rip” of this command
disables the RIPng routing protocol.
Default:
RIPng routing not running.
Command Mode:
Global mode
Usage Guide:
This command is for enabling the RIPng routing protocol, this command should be enabled before
performing other global configuration of the RIPng protocol.
Example:
Enable the RIPng protocol mode.
Switch(config)#router ipv6 rip
32.19 show debugging ipv6 rip
Command:
show debugging ipv6 rip
Function:
Show RIPng debugging status for following debugging options: nsm debugging, RIPng event
debugging, RIPng packet debugging and RIPng nsm debugging.
Command Mode:
Admin mode
Example:
Switch#show debugging ipv6 rip
RIPng debugging status:
RIPng event debugging is on
RIPng packet detail debugging is on
RIPng NSM debugging is on