PLANET XGS3-24040 - Manual (Page 721)

XGS3 Command Guide
39-53
39.8.2 clear ipv6 mld snooping vlan <1-4094>
mrouter-port
Command: clear ipv6 mld snooping vlan <1-4094> mrouter-port [ethernet IFNAME|IFNAME]
Function: Delete the mrouter port of the specific VLAN.
Parameters: <1-4094> the specific VLAN ID; ethernet the Ethernet port name; IFNAME the port name.
Command Mode: Admin Configuration Mode
Usage Guide: Use show command to check the deleted group record.
Example: Delete the mrouter port in vlan 1.
Switch# clear ipv6 mld snooping vlan 1 mrouter-port
Relative Command: show ipv6 mld snooping mrouter-port
39.8.3 debug mld snooping all/packet/event/timer/mfc
Command: debug mld snooping all/packet/event/timer/mfc
no debug mld snooping all/packet/event/timer/mfc
Function: Enable the debugging of the switch MLD Snooping; the “no” form of this command disables
the debugging.
Command Mode: Admin Mode
Default: The MLD Snooping Debugging of the switch is disabled by default
Usage Guide: This command is used for enabling the switch MLD Snooping debugging, which displays
the MLD data packet message processed by the switch——packet, event messages——event, timer
messages——timer,messages of down streamed hardware entry——mfc,all debug messages——all.
39.8.4 ipv6 mld snooping
Command: ipv6 mld snooping
no ipv6 mld snooping
Function: Enable the MLD Snooping function on the switch; the “no ipv6 mld snooping” command
disables MLD Snooping.
Command Mode: Global Mode
Default: MLD Snooping disabled on the switch by default
Usage Guide: Enable global MLD Snooping on the switch, namely allow every vlan to be configured with
MLD Snooping; the “no” form of this command will disable MLD Snooping on all the vlans as well as the
global MLD snooping
Example: Enable MLD Snooping under global mode.
Switch (config)#ipv6 mld snooping