PLANET XGS3-24040 - Manual (Page 229)

14-95
Parameters:
input applies the specified policy map to the ingress redirection of switch port
or VLAN interface.
Default:
No policy map is bound to port and VLAN interface by default.
Command mode:
Interface Configuration Mode(Switch port or VLAN interface).
Usage Guide:
Configuring port trust status and applying policy map on the port are two conflicting operations; the
later configuration will override the earlier configuration. Only one policy map can be applied to each
direction of each port or VLAN interface. Egress policy map is not supported yet.
Example:
Bind policy p1 to ingress Ethernet port 1/1.
Switch(config)#interface ethernet 1/1
Switch(Config-If-Ethernet1/1)#service-policy input p1
Bind policy p1 to ingress redirection of v1 interface.
Switch(config)#interface vlan 1
Switch(Config-If-vlan1)#service-policy input p1
14.12 show class-map
Command:
show class-map [<class-map-name>]
Function:
Displays class map of QoS.
Parameters:
< class-map-name> is the class map name.
Default:
N/A.
Command mode:
Admin Mode.
Usage Guide:
Displays all configured class-map or specified class-map information.
Example:
Switch # show class-map
Class map name:c1, used by 1 times
match acl name:1