PLANET XGS3-24040 - Manual (Page 512)

34-225
34.38 show ipv6 route process-detail
Command: show ipv6 route [database] process-detail
Function: Display the IP routing table with specific process ID or Tag.
Parameters: The parameter of database means displaying all the routers, no parameter means only
displaying effective routers.
Command Mode: Admin mode and configure mode.
Usage Guide: None.
Example:
Switch#show ipv6 route database process-detail
IPv6 Routing Table
Codes: K - kernel route, C - connected, S - static, R - RIP, O - OSPF,
I - IS-IS, B - BGP
> - selected route, * - FIB route, p - stale info
Timers: Uptime
C*> ::1/128 via ::, Loopback, 00:29:53
O 2001::/64 [110/10] via ::, Vlan1, 00:01:07 ,process aaa
C*> 2001::/64 via ::, Vlan1, 00:02:54
O*> 2006::/64 [110/10] via ::, Vlan1, 00:01:07, process aaa
O*> 2008::/64 [110/20] via fe80::203:fff:fe01:2542, Vlan1, 00:00:54, process bbb
34.39 timers spf
Command: timers spf <spf-delay> >
no timers spf
Function: Adjust route calculation timer value. The “no timers spf” restores the relevant value to default.
Parameter: 5 seconds by default
10 seconds by default
Command Mode: OSPFv3 protocol mode
Usage Guide: In this command the delay time between receiving topology change and SPF calculation,
and further configured the hold time between two discontinuous SPF calculations.
Example:
Switch # config terminal
Switch (config)# router ipv6 ospf
Switch(config-router)#timers spf 5 10