PLANET XGS3-24040 - Manual (Page 182)

11-48
11.3.2 switchport voice-vlan enable
Command:
switchport voice-vlan enable
no switchport voice-vlan enable
Function:
Enable the Voice VLAN function on the port; the “no” form of this command disables Voice VLAN
function on the port.
Parameter:
None.
Command Mode:
Port Mode.
Default:
Voice VLAN is enabled by default.
Usage Guide:
When voice equipment is added to the Voice VLAN, the Voice VLAN is enabled globally by default.
This command disables Voice VLAN on specified port to meet specified application of the user.
Example:
Disable the Voice VLAN function on port3.
Switch#config
Switch(config)#interface ethernet 1/3
Switch(Config-If-Ethernet1/3)#no switchport voice-vlan enable
11.3.3 voice-vlan
Command:
voice-vlan mac mask priority [name
]
no voice-vlan {mac mask |name |all}
Function:
Specify certain voice equipment to join in Voice VLAN; the "no" form of this command will let the
equipment leave the Voice VLAN.
Parameter:
Mac-address is the voice equipment MAC address, shown in ”xx-xx-xx-xx-xx-xx” format; mac-mask
is the last eight digit of the mask code of the MAC address, the valid values are: 0xff, 0xfe, 0xfc,
0xf8, 0xf0, 0xe0, 0xc0,0x80, 0x0; priority-id is the priority of the voice traffic, the valid range is 0–7;
the voice-name is the name of the voice equipment, which is to facilitate the equipment
management; all indicates all the MAC addresses of the voice equipments.
Command Mode:
Global Mode.
Default: