PLANET XGS3-24040 - Manual (Page 587)

XGS3 Command Guide
38-16
no debug pim timer joinprune et
no debug pim timer joinprune jt
no debug pim timer joinprune kat
no debug pim timer joinprune ot
no debug pim timer joinprune plt
no debug pim timer joinprune ppt
no debug pim timer joinprune pt
no debug pim timer joinprune
no debug pim timer register rst
no debug pim timer register
Function: Enable or Disable each pim timer
Parameter: None
Default: Disabled
Command Mode: Admin Mode.
Usage Guide: Enable the specified timer’s debug information.
Example:
Switch# debug pim timer assert
38.3.10 ip mroute
Command: ip mroute <A.B.C.D> <A.B.C.D> <ifname> <.ifname>
no ip mroute <A.B.C.D> <A.B.C.D> [<ifname> <.ifname>]
Function: To configure static multicast entry. The no command will delete some static multicast entries or
some egress interfaces.
Parameter: are the source address and group address of multicast.
<ifname> <.ifname>, the first one is ingress interface, follow is egress interface.
Default: To delete this static multicast entry, if the command isn’t included interface parameter.
Command Mode: Global Mode.
Usage Guide: The should be valid VLAN interfaces. The multicast data flow will not be
forwarded unless PIM is configured on the egress interface and the interface is UP. If the state of the
interface is not UP, or PIM is not configured, or RPF is not valid, the multicast data flow will not be
fordwarded. To removed the specified multicast routing entry. If all the egress interfaces are specified, or
no interfaces are specified, the specified multicast routing entry will be removed. Otherwise the multicast
routing entry for the specified interface will be removed.
Example:
Switch(config)#ip mroute 10.1.1.1 225.1.1.1 v10 v20 v30
38.3.11 ip pim accept-register
Command: ip pim accept-register list <list-number>
no ip pim accept-register
Function: Filter the specified multicast group and multicast address.
Parameter: <list-number>: <list-number> is the access-list number ,it ranges from 100 to 199.