PLANET XGS3-24040 - Manual (Page 522)

35-235
35.20 bgp inbound-route-filter
Command: bgp inbound-route-filter
no bgp inbound-route-filter
Function: The bgp do not install the RD routing message which does not exist locally. The “no bgp
inbound-route-filter” command means the RD will be installed with no regard to the local existence of
the RD.
Parameter: None.
Command Mode: BGP route mode.
Usage Guide: Normally when the switch plays as PE, whether the route bgp acquired from VPN is
saved in BGP depends on if the VRF configured in this PE has got matched information. With the “no
bgp inbound-route-filter” command the BGP will save the routing message with no regard to the
matched information.
Example:
Switch(config)#router bgp 100
Switch(config-router)#no bgp inbound-route-filter
35.21 bgp inbound-max-route-num
Command: bgp inbound-max-route-num <0-500000>
no bgp inbound-max-route-num
Function: Set the number limit of routers learnt by the bgp process from its neighbors.
Parameters: The number limit of routers, ranging from 0 to 500000.
Default: The number limit is 50000 by default.
Command Mode: BGP routing mode and address family mode
Usage Guide: Limit the number of routers learnt by the bgp process from its neighbors with this
command.
Example: The following configuration will limit max number of routers that the bgp process receives from
its neighbors as 20000.
Switch(config-router)# bgp inbound-max-route-num 20000