PLANET XGS3-24040 - Manual (Page 554)

35-267
Usage Guide: Route from other ways will be distributed into the BGP route table with this command and
transmitted to the neighbors.
Example: The static route is introduced into BGP with this configuration and advertised to the neighbors.
Switch(config-router)# redistribute static
35.84 redistribute ospf
Command: redistribute ospf [<process-id>] [route-map<word>]
no redistribute ospf [<process-id>]
Function: To redistribute routing information form OSPF to BGP. The no form of this command will
remove the configuration.
Parameters: process-id is the process ID of the OSPF, limited between 1 and 65535. If no process id is
specified, the default process id will be used.
route-map<word> is the pointer to the introduced routing map.
Default: Not redistributed by default.
Command Mode: BGP Configuration Mode.
Usage Guide: None.
Example: To redistribute routing of OSPF v2 to BGP (as number is 1).
Switch(config)#router bgp 1
Switch (config-router)#redistribute ospf 2
35.85 redistribute ospf (MBGP4+)
Command: redistribute ospf [<process-tag>] [route-map<word>]
no redistribute ospf [<process-tag>]
Function: To redistribute routing information form OSPFv3 to MBGP4+. The no form of this command
will remove the configuration.
Parameters: process-id is the process character string of the OSPFv3, the length is less than 15. If no
process id is specified, the default process will be used.
route-map<word> is the pointer to the introduced routing map.
Default: Not redistributed by default.
Command Mode: BGP IPv6 Configuration Mode.
Usage Guide: None.
Example: To redistribute routing information from OSPFv3 process with the tag as ABC to MBGP4+ (as
number as 1).
Switch (config)#router bgp 1