7 commands for dvmrp, 1 debug dvmrp, 2 ip dvmrp enable – PLANET XGS3-24040 User Manual

Page 629: Ommands for, Dvmrp

XGS3 Command Guide

38-58

38.7 Commands for DVMRP
38.7.1 debug dvmrp

Command:

nsm|mfc|mib|timer [probe[probe-timer|neighbor-expiry-timer]|

prune[prune-expiry-timer|prune-retx-timer|graft-retx-timer]|route[report-timer|flash-up

d-timer|route-expiry-timer|route-holdown-timer|route-burst-timer]]|packet[[probe

[in|out] | report [in|out | prune [in|out] graft [in|out] | graft-ack [in|out] |in|out]]|all]

no debug dvmrp [events[neighbor|packet|igmp|kernel|prune [detail]

|route]|nsm|mfc|mib|timer[probe[probe-timer|neighbor-expiry-timer]|prune[prune-expir

prune [in|out] graft [in|out] | graft-ack [in|out] |in|out]]|all]

Function:

Display DVMRP protocol debugging message; the “no

debug dvmrp

mfc|mib|timer [probe[probe-timer|neighbor-expiry-timer]|

prune[prune-expiry-timer|prune-retx-timer|graft-retx-timer]|

route[report-timer|flash-upd-timer|route-expiry-timer|

route-holdown-timer|route-burst-timer]]

|packet[[probe [in|out] | report [in|out | prune [in|out] graft [in|out] | graft-ack [in|out]

|in|out]]|all]” command disenables this debugging switch.

Parameter: None

Default: Disabled

Command Mode: Admin Mode

Usage Guide: Enable this switch, and display DVMRP protocol executed relevant messages.

38.7.2 ip dvmrp enable

Command: ip dvmrp enable

no ip dvmrp

Function: Configure to enable DVMRP protocol on interface; the “no ip dvmrp” command disenables

DVMRP protocol.

Parameter: None

Default: Disable DVMRP Protocol

Command Mode: Interface Configuration Mode

Usage Guide: The interface processes DVMRP protocol messages, only executing DVMRP protocol on

interface.

Example: Enable DVMRP Protocol on interface vlan1.

Switch (config)#interface vlan 1

Switch(Config-If-vlan1)#ip dvmrp enable