PLANET XGS3-24040 - Manual (Page 832)

Commands for Reliability Chapter 4 Commands for ULPP
57-7
Parameter: [group-id]: Show the information of the specific ULPP group.
Default: By default, show the information of all ULPP groups which have been configured.
Command mode: Admin mode.
Usage Guide: Show the configuration information of ULPP groups which have been configured, such as:
the state of the master port and the slave port, the preemption mode, the preemption delay, etc.
Example: Show the configuration information of ULPP group1.
Switch# show ulpp group 1
ULPP group 1 information:
Description: abc
Preemption mode: on
Preemption delay: 30s
Control VLAN:1
Protected VLAN: Reference Instance 1
Member Role State
--------------------------------------------------------------
Ethernet1/1 MASTER FORWARDING
Ethernet1/2 SLAVE STANDBY
57.18 ulpp control vlan
Command: ulpp control vlan
no ulpp control vlan
Function: Configure the receiving control VLANs of the port, the no command restores the default value.
Parameter: specify the control VLAN list that receives the flush packets, such as: i; j-k. The
number of VLANs in Each character string can not exceed 100. The receiving control VLAN of the port
can be added.
Default: The default is VLAN 1.
Command mode: Port mode.
Usage Guide: Configure the receiving control VLAN of the port. The control VLAN has no relation with
the data VLAN whether exist or not, it is only used to match the sending control VLAN of the packets.
Example: Configure the receiving control VLAN as 10.
Switch(config)# interface ethernet 1/1
Switch(config-If-Ethernet1/1)# ulpp control vlan 10
57.19 ulpp flush disable arp
Command: ulpp flush disable arp
Function: Disable receiving the flush packets of deleting ARP.
Parameter: None.
Default: By default, disable receiving the flush packets of deleting ARP.
Command mode: Port mode.
Usage Guide: If this command is configured, then it will not receive the flush packets of deleting ARP.