6 ip dvmrp reject-non-pruners, 7 ip dvmrp tunnel – PLANET XGS3-24040 User Manual
Page 631
XGS3 Command Guide
38-60
<burst_size> is a quantity of transmitted message every time, value range from 1 to 65535
Default: Default the delay of transmitted DVMRP report message as 1s, default: transmitting two
messages every time.
Command Mode: Interface Configuration Mode
Usage Guide: Avoid message burst if setting an appropriate delay.
Example:
Switch (Config-If-vlan1)#ip dvmrp output-report-delay 1 1024
38.7.6 ip dvmrp reject-non-pruners
Command: ip dvmrp reject-non-pruners
no ip dvmrp reject-non-pruners
Function: Configure to reject neighbor ship with DVMRP router of non pruning/grafting on the interface,
the “no ip dvmrp reject-non-pruners” command restores neighbor ship can be established.
Parameter: None
Default: Default
Command Mode: Interface Configuration Mode
Usage Guide: The command determines if it will establish neighboringship with DVMRP router of non
pruning/grafting or not.
Example:
Switch (Config-If-vlan1)#ip dvmrp reject-non-pruners
38.7.7 ip dvmrp tunnel
Command: ip dvmrp tunnel <index> <src-ip> <dst-ip>
no ip dvmrp tunnel {<index> |<src-ip> <dst-ip>}
Function: Configure a DVMRP tunnel; the “no ip dvmrp tunnel {<index> |<src-ip> <dst-ip>}”
command deletes a DVMRP tunnel.
Parameter:
Default: Do not Configure DVMRP tunnel.
Command Mode: Global Mode
Usage Guide: Because not all of switches support multicast, DVMRP supports tunnel multicast
communication. The tunnel is a way of transmitted multicast data packet among DVMRP switches
partitioned off switches without supporting multicast routing. It acts as a virtual network between two
DVMRP switches. Multicast data packets packed in unicast data packets, directly are transmitted to next
supporting multicast switch. DVMRP protocol equally deal with tunnel interface and general physical
interface. After configuring no ip dv multicast-routing, all of the tunnel configurations are deleted.
Example:
Switch(config)#ip dvmrp tunnel 1 12.1.1.1 24.1.1.1