PLANET XGS3-24040 - Manual (Page 110)

XGS3 Command Guide
4-110
iber connected, copper not connected
Copper cable port
Fiber cable port
Fiber cable port
Fiber cable port
Copper connected, fiber not connected
Copper cable port
Copper cable port
Fiber cable port
Copper cable port
Both fiber and copper are connected
Copper cable port
Copper cable port
Fiber cable port
Fiber cable port
Neither fiber nor copper are connected
Copper cable port
Fiber cable port
Fiber cable port
Fiber cable port
1. Combo port is a conception involving the physical layer and the LLC sublayer of the datalink layer. The status of a
combo port will not affect any operation in the MAC sublayer of the datalink layer and upper layers. If the
bandwidth limit for a combo port is 1Mbps, then this 1Mbps applies to the active port of this combo port, regardless
of the port type being copper or fiber.
2. If a combo port connects to another combo port, it is recommended for both parties to use copper-forced or
fiber-forced mode.
3. Run show interface under Admin Mode to check for the active port of a combo port .The following result indicates if
the active port for a combo port is the fiber cable port: Hardware is Gigabit-combo, active is fiber.