PLANET XGS3-24040 - Manual (Page 359)

27-72
27.10 ip dhcp snooping binding dot1x
Command:
ip dhcp snooping binding dot1x
no ip dhcp snooping binding dot1x
Function:
Enable the DHCP Snooping binding DOT1X funciton.
Parameters:
None
Command Mode:
Port mode
Default Settings:
By default, the binding DOT1X funciton is disabled on all ports.
Usage Guide:
When this function is enabled, DHCP SNOOPING will notify the DOT1X module about the captured
bindng information as a DOT1X controlled user. This command is mutually exclusive to”ip dhcp
snooping binding user-contro“command.
Only after the DHCP SNOOPING binding function is enabled, the binding ARP function can be set.
Example:
Enable the binding DOT1X funciton on port ethernet1/1.
switch(config)#interface ethernet 1/1
switch(Config- Ethernet 1/1)# ip dhcp snooping binding dot1x
Relative Command:
ip dhcp snooping binding enable
ip dhcp snooping binding user-control
27.11 ip dhcp snooping binding user-control
Command:
ip dhcp snooping binding user-control
no ip dhcp snooping binding user-control
Function:
Enable the binding user funtion.
Parameters:
None.
Command Mode:
Port Mode.
Default Settings:
By default, the binding user funciton is disabled on all ports.
Usage Guide:
When this function is enabled, DHCP SNOOPING will treat the captured binding information as
trusted users allowed to access all resources. This command is mutually exclusive to“ ip dhcp