PLANET XGS3-24040 - Manual (Page 578)

XGS3 Command Guide
38-7
Switch (Config-if-Vlan1)#ip pim neighbor-filter 2
Switch (config)#access-list 2 deny 10.1.4.10 0.0.0.255
Switch (config)#access-list 2 permit any-source
Switch (config)#show ip pim neighbor
Switch (config)#
38.2.12 ip pim scope-border
Command: ip pim scope-border [<1-99 >|<acl_name>]
no ip pim scope-border
Function: To configure or delete management border of PIM.
Parameters: <1-99 >: is the ACL number for the management border.
<acl_name>: is the ACL name for the management border.
Default: Not management border. If no ACL is specified, the default management border will be used.
Command Mode: Interface Configuration Mode.
Usage Guide: To configure the management border and the ACL for the PIM protocol. The multicast
data flow will not be forwarded to the SCOPE-BORDER.
Example:
Switch(Config-if-Vlan2)#ip pim scope-border 3
38.2.13 ip pim state-refresh origination-interval
Command: ip pim state-refresh origination-interval
no ip pim state-refresh origination-interval
Function: Configure transmission interval of state-refresh message. The “no ip pim state-refresh
origination-interval” command restores default value.
Parameter: <interval> packet transmission interval value is from 4s to 100s.
Default: 60s
Command Mode: Global Mode
Usage Guide: The first-hop router periodically transmits stat-refresh messages to maintain PIM-DM list
items of all the downstream routers. The command can modify origination interval of state-refresh
messages. Usually do not modify relevant timer interval.
Example: Configure transmission interval of state-refresh message to 90s.
Switch (config)#ip pim state-refresh origination-interval 90
38.2.14 show ip pim interface
Command: show ip pim interface