PLANET XGS3-24040 - Manual (Page 623)

XGS3 Command Guide
38-52
Example:
Switch(config)#router msdp
Switch(router-msdp)#ttl-threshold 10
38.5 Commands for ANYCAST RP v4
38.5.1 debug pim anycast-rp
Command: debug pim anycast-rp
no debug pim anycast-rp
Function: Enable the debug switch of ANYCAST RP function; the no operation of this command will
disable this debug switch.
Command Mode: Admin Mode.
Default: The debug switch of ANYCAST RP is disabled by default.
Usage Guide: This command is used to enable the debug switch of ANYCAST RP of the router, it can
display the information of handling PIM register packet of the switch——packet, and the information of
events——event.
Example:
Switch#debug pim anycast-rp
38.5.2 ip pim anycast-rp
Command: ip pim anycast-rp
no ip pim anycast-rp
Function: Enable the ANYCAST RP of the switch; the no operation of this command is to disable the
ANYCAST RP function.
Command Mode: Global Configuration Mode.
Default: The switch will not enable the ANYCAST RP by default.
Usage Guide: This command will globally enable ANYCAST RP protocol, but in order to make
ANYCAST RP work, it is necessary to configure self-rp-address and other-rp-address set.
Example: Enable ANYCAST RP in global configuration mode.
Switch(config)#ip pim anycast-rp
38.5.3 ip pim anycast-rp
Command: ip pim anycast-rp <anycast-rp-addr>
no ip pim anycast-rp <anycast-rp-addr>
Function: Configure ANYCAST RP address （ ARA ） and the unicast addresses of other RP
communicating with this router(as a RP). The no operation of this command will cancel the unicast
address of another RP in accordance with the configured RP address.
Parameters: anycast-rp-addr: RP address, the absence of the candidate interface in accordance with
the address is allowed.
other-rp-addr: The unicast address of other RP communicating with this router(as a RP).