PLANET XGS3-24040 - Manual (Page 761)

Commands for Security Function Chapter 2 Commands for 802.1x
42-33
Switch(config)#dot1x web authentication enable
42.25 dot1x web redirect
Command: dot1x web redirect
no dot1x web redirect
Function: Set the HTTP server address for Web redirection, the no command clears the address.
Parameters: is HTTP server address, in dotted decimal notation.
Default: The redirection function is disabled.
Command mode: Global Mode.
Usage Guide: The Web authentication function must be enabled before setting the Web server address.
The URL format is http://A.B.C.D[:E]/F, A.B.C.D is the IP address; E is the HTTP service port number,
default value is 80; F is a string of character and the command do not do the validation checking on it.
Example: Set the Web redirection address as http://192.168.20.20/WebSupplicant.
Switch(config)#dot1x web redirect http://192.168.20.20/WebSupplicant/
42.26 dot1x web redirect enable
Command: dot1x web redirect enable
no dot1x web redirect enable
Function: To enable unauthenticated user to visit Web redirect function. After enable this function, if
unauthenticated user try to visit Website resource not for free (The http visiting required destination port
is 80 here), the switch can configure Web visiting redirect to specified website, then remind user to
authenticate. The Website IP can configure in inter security management background system TrustView,
only can configure IP address and not support domain name.
Parameter: None.
Command Mode: Global Mode.
Default: The unauthenticated user Web redirect function is disabled by default. Manager can configure
redirect function in inter security management background system, this address can transmit to switch
through private communication protocol between switch and background system.
Usage Guide:
Example: Enable the unauthenticated user to visit the redirect function through Web.
Switch(Config)# dot1x web redirect enable
42.27 show dot1x
Command: show dot1x [interface <interface-list>]
Function: Displays dot1x parameter related information, if parameter information is added,
corresponding dot1x status for corresponding port is displayed.
Parameters: is the port list. If no parameter is specified, information for all ports is
displayed.
Command mode: Admin and Configuration Mode.
Usage Guide: The dot1x related parameter and dot1x information can be displayed with “show dot1x”
command.