PLANET XGS3-24040 - Manual (Page 675)

XGS3 Command Guide
39-7
Switch(config_IPv6_Std-Nacl-myfilter)#permit any
39.2.12 ipv6 pim scope-border
Command: ipv6 pim scope-border [<500-599>|<acl_name>]
no ipv6 pim scope-border
Function: To configure or delete management border of PIM6.
Parameters: <500-599> is the ACL number for the management border.
<acl_name> is the ACL name for the management border.
Default: Not management border. If no ACL is specified, the default management border will be used.
Command Mode: Interface Configuration Mode.
Usage Guide: To configure the management border and the ACL for the IPV6 PIM. The multicast data
flow will not be forwarded to the SCOPE-BORDER.
Example:
Switch(Config-if-Vlan2)#ipv6 pim scope-border 503
39.2.13 ipv6 pim state-refresh origination-interval
Command: ipv6 pim state-refresh origination-interval
no ipv6 pim state-refresh origination-interval
Function: Configure transmission interval of state-refresh message on interface. The “no ipv6 pim
state-refresh origination-interval” command restores default value.
Parameter: <interval> message transmission interval value is from 4s to 100s.
Default: 60s
Usage Guide: The first-hop router periodically transmits stat-refresh messages to maintain PIM-DM list
ltems of all the downstream routers. The command can modify origination interval of state-refresh
messages. Usually do not modify relevant timer interval. The command can configure on IPv6 tunnel
interface, but it is successful configuration to only configure tunnel carefully.
Example: Configure transmission interval of state-refresh message on interface vlan1 to 90s.
Switch (Config-if-Vlan1)#ipv6 pim state-refresh origination-interval 90
39.2.14 show ipv6 pim interface
Command: show ipv6 pim interface [detail]
Function: Display PIM interface information.
Parameter: None
Default: None
Command Mode: Any Mode