PLANET XGS3-24040 - Manual (Page 298)

19-11
Switch(config)#ip arp -security convert
19.6 ipv6 nd-security convert
Command:
ipv6 nd-security convert
Function:
Change all of dynamic ND to static ND.
Parameter:
None
Command Mode:
Global Mode/ Interface Configuration
Usage Guide:
This command will convert the dynamic ND entries to static ones, which, in combination with
disabling automatic learning, can prevent ND binding. Once implemented, this command will lose
its effect.
Example:
Switch(Config-if-Vlan1)#ipv6 nd -security convert
Switch(config)#ipv6 nd -security conver
19.7 clear ip arp dynamic
Command:
clear ip arp dynamic
Function:
Clear all of dynamic ARP on interface.
Parameter:
None
Command Mode:
Interface Configuration
Usage Guide:
This command will clear dynamic entries before binding ARP. Once implemented, this command will
lose its effect.
Example:
Switch(Config-if-Vlan1)#clear ip arp dynamic
19.8 clear ipv6 nd dynamic
Command:
clear ipv6 nd dynamic
Function:
Clear all of dynamic ND on interface.