PLANET XGS3-24040 - Manual (Page 690)

XGS3 Command Guide
39-22
Function: This command is used to configure the speedrate of DR sending register packets, the unit is
packet/second. The “no ipv6 pim Register-rate-limit” command restores the default value. This
configured speedrate is each（S, G）state’s, not the whole systems.
Parameter: ranges from 1 to 65535
Default: No limit for sending speed
Command Mode: Global Mode
Usage Guide: Configure the speedrate of DR sending register packets.
Example: Configure the speedrate of DR sending register packets to 59 p/s.
Switch(config)#ipv6 pim Register-rate-limit 59
39.3.24 ipv6 pim register-rp-reachability
Command: ipv6 pim Register-rp-reachability
no ipv6 pim Register-rp-reachability
Function: This command makes DR check the RP reachability in the process of registration.
Parameter: None
Default: Do not check.
Command Mode: Global Mode.
Usage Guide: This command configures DR whether or not to check the RP reachability.
Example: Configure the router to check the RP reachability before sending register packets.
Switch(config)# ipv6 pim Register-rp-reachability
39.3.25 ipv6 pim register-source
Command: ipv6 pim register-source {<source-address> |<ifname>|vlan }
no ipv6 pim register-source
Function: This command is to configure the source address of register packets sent by DR to overwrite
default source address. This default source address is usually the RPF neighbor of source host direction.
Parameter: <ifname> is the interface name that will be the register packets source.
<source-address> is the interface address will be the register packets source. In the format
of hex without prefix length.
is the VLAN ID.
Default: Do not check.
Command Mode: Global Mode
Usage Guide: The “no ipv6 pim register-source” command restores the default value, no more
parameter is needed. Configured address must be reachable to Register-Stop messages sent by RP. It’s
usually a circle address, but it can be other physical addresses. This address must be announcable
through unicast router protocols of DR.
Example: Configure the source address of the sent register packets to vlan1’s address
Switch(config)# ipv6 pim register-source Vlan1