PLANET XGS3-24040 - Manual (Page 656)

XGS3 Command Guide
38-85
Usage Guide: It is recommended to use the default settings. Please keep this configure in accordance
with IGMP configuration as possible if layer 3 IGMP is running.
Example:
Switch(config)#ip igmp snooping vlan 2 query-interval 130
38.10.14 ip igmp snooping vlan query-mrsp
Command: ip igmp snooping vlan <vlan-id> query-mrsp <value>
no ip igmp snooping vlan <vlan-id> query-mrsp
Function: Configure the maximum query response period. The “no ip igmp snooping vlan <vlan-id>
query-mrsp” command restores to the default value.
Parameter: vlan-id: vlan id , ranging between <1-4094>
value: ranging between <1-25> seconds
Command Mode: Global mode
Default: 10s
Usage Guide: It is recommended to use the default settings. Please keep this configure in accordance
with IGMP configuration as possible if layer 3 IGMP is running.
Example:
Switch(config)#ip igmp snooping vlan 2 query-mrsp 18
38.10.15 ip igmp snooping vlan query-robustness
Command: ip igmp snooping vlan query-robustness <value>
no ip igmp snooping vlan query-robustness
Function: Configure the query robustness. The “no ip igmp snooping vlan
query-robustness” command restores to the default value.
Parameter: vlan-id: vlan id, ranging between <1-4094>
value: ranging between <2-10>
Command Mode: Global mode
Default: 2
Usage Guide: It is recommended to use the default settings. Please keep this configure in accordance
with IGMP configuration as possible if layer 3 IGMP is running.
Example:
Switch(config)#ip igmp snooping vlan 2 query- robustness 3
38.10.16 ip igmp snooping vlan report source-address
Command: ip igmp snooping vlan report source-address
no ip igmp snooping vlan report source-address
Function: Configure forward report source-address for IGMP, the “no ip igmp snooping vlan
report source-address” command restores the default setting.
Parameter: vlan-id: vlan id range<1-4094>;
A.B.C.D: IP address, can be 0.0.0.0.