PLANET XGS3-24040 - Manual (Page 577)

XGS3 Command Guide
38-6
Command Mode: Interface Configuration Mode.
Usage Guide: Hello message makes PIM-DM switch mutual location, and ensures neighborship.
PIM-DM switch announces existence itself by periodically transmitting hello messages to neighbors. If it
doesn’t receive hello messages from neighbors in regulation time, it confirms that the neighbors were lost.
Configuration time is not more than neighbor overtime.
Example: Configure PIM-DM hello interval on interface vlan1.
Switch (config)#interface vlan1
Switch(Config-if-Vlan1)#ip pim hello-interval 20
38.2.10 ip pim multicast-routing
Command: ip pim multicast-routing
no ip pim multicast-routing
Function: Enable PIM-SM globally. The “no ip pim multicast-routing » command disables PIM-SM
globally.
Parameter: None
Default: Disabled PIM-SM
Command Mode: Global Mode
Usage Guide: Enable PIM-SM globally. The interface must enable PIM-SM to have PIM-SM work
Example: Enable PIM-SM globally.
Switch (config)#ip pim multicast-routing
38.2.11 ip pim neighbor-filter
Command: ip pim neighbor-filter <list-number>
no ip pim neighbor-filter <list-number>
Function: Configure the neighbore access-list. If filtered by the lists and connections with neighbors are
created, this connections are cut off immediately. If no connection is created, this conncetion can’t be
created.
Parameter: <list-number>: <list-number> is the simple access-list number, it ranges from 1 to 99
Default: No neighbor filter configuration.
Command Mode: Interface Configuration Mode
Usage Guide: ACL’s default is DENY. If configuring access-list 1,access-list 1’s default is deny. In the
following example, if “permit any-source” is not configured, deny 10.1.4.10 0.0.0.255 is the same as deny
any-source.
Example: Configure vlan’s filtering rules of pim neighbors.
Switch #show ip pim neighbor
Neighbor Interface Uptime/Expires Ver DR
Address Priority/Mode
10.1.4.10 Vlan1 02:30:30/00:01:41 v2 4294967294 / DR