PLANET XGS3-24040 - Manual (Page 724)

XGS3 Command Guide
39-56
Example:
Switch(config)#ipv6 mld snooping vlan 2 mrouter-port interface ethernet1/13
39.8.10 ipv6 mld snooping vlan mrpt
Command: ipv6 mld snooping vlan <vlan-id> mrpt <value>
no ipv6 mld snooping vlan <vlan-id> mrpt
Function: Configure the keep-alive time of the mrouter port.
Parameter: vlan-id: VLAN id, the valid range is <1-4094>
value: mrouter port keep-alive time with a valid range of <1-65535> secs.
Command Mode: Global Mode
Default: 255s
Usage Guide: This configuration is applicable on dynamic mrouter port, but not on static mrouter port. To
use this command, MLD snooping must be enabled on the VLAN.
Example:
Switch(config)#ipv6 mld snooping vlan 2 mrpt 100
39.8.11 ipv6 mld snooping vlan query-interval
Command: ipv6 mld snooping vlan <vlan-id> query-interval <value>
no ipv6 mld snooping vlan <vlan-id> query-interval
Function: Configure the query interval.
Parameter: vlan-id: VLAN id, the valid range is <1-4094>
value: query interval, valid range: <1-65535>secs.
Command Mode: Global Mode
Default: 125s
Usage Guide: It is recommended to use default value and if layer 3 MLD is in operation, please make
this configuration in accordance with the MLD configuration as possible.
Example:
Switch(config)#ipv6 mld snooping vlan 2 query-interval 130
39.8.12 ipv6 mld snooping vlan query-mrsp
Command: ipv6 mld snooping vlan <vlan-id> query-mrsp <value>
no ipv6 mld snooping vlan <vlan-id> query-mrsp
Function: Configure the maximum query response period. The “no” form of this command restores the
default value.
Parameter: vlan-id: VLAN id, the valid range is<1-4094>
value: the valid range is <1-25> secs .
Command Mode: Global Mode
Default: 10s
Usage Guide: It is recommended to use default value and if layer 3 MLD is in operation, please make
this configuration in accordance with the MLD configuration as possible.