PLANET XGS3-24040 - Manual (Page 408)

31-121
key-string
key chain
send-lifetime
31.2 address-family ipv4
Command:
address-family ipv4 vrf <vrf-name>
no address-family ipv4 vrf
Function:
Configure this command to enable the routing message switching among VRF and enter the
address-family mode. The “no address-family ipv4 vrf ” command deletes the RIP
instances related to this VPN routing/forwarding instance.
Parameter:
specifies the name of VPN routing/forwarding instances.
Command Mode:
router mode
Usage Guide:
This command is only used on PE router. A VPN routing/forwarding instance must be generated
with command ip vrf prior to using this command by which the VPN routing/forwarding instances
can be related to RIP instances.
Example:
Switch# config terminal
Switch(config)# router rip
Switch(config-router)# address-family ipv4 vrf VRF1
Switch(config-router-af)#
31.3 clear ip rip route
Command:
clear ip rip route { | kernel | static | connected | rip | ospf | isis | bgp | all}
Function:
Clear specific route in the RIP route table.
Parameter:
Clear the routes which match the destination address from the RIP route table.
specifies the IP address prefix and its length of the destination address
kernel delete kernel routes from the RIP route table
static delete static routes from the RIP route table
connected delete direct routes from the RIP route table