PLANET XGS3-24040 - Manual (Page 604)

XGS3 Command Guide
38-33
Example:
Switch(config)#router msdp
Switch(router-msdp)#cache-sa-maximum50000
Switch(router-msdp)#peer 20.1.1.1
Switch(router-msdp-peer)# cache-sa-maximum 22000
38.4.3 cache-sa-state
Command: cache-sa-state
no cache-sa-state
Function: To configure the SA cache state of route.
Parameter: None.
Command Mode: MSDP Configuration Mode and MSDP Peer Configuration Mode.
Default: Enabled.
Usage Guide: To configure the SA cache state. If configured, the new groups will be able to get
information about all the active sources from the SA cache and join the related source tree without having
to wait for new SA messages. SA-cache should be enabled on all the MSDP speakers. The no form of
this command will remove the configuration of SA cache. To be mentioned, this command should be
issued exclusively with the sa-request command.
Example:
Switch(config)#router msdp
Switch(router-msdp)#no cache-sa-state
38.4.4 clear msdp peer
Command: clear msdp peer {peer-address| *}
Function: Disconnected between specified MSDP Peer and TCP, to clear the statistics of the Peer.
Parameter: peer-address: The IP address of the Peer;
* Disconnected with all the Peers.
Command Mode: Admin Mode.
Default: None.
Usage Guide: If this command is issued with peer-address, the TCP connection to the specified MSDP
Peer will be removed. And all the statistics about the peer will be cleared. If no peer-address is appended,
all the MSDP connections as long as relative statistics about peers will be removed.
Example:
Switch#clear msdp peer *