PLANET XGS3-24040 - Manual (Page 310)

23-23
Switch(config)#ipv6 nd snooping static-binding 2001::2:1 hardware-address 00-11-22-33-44-55
interface ethernet1/1
23.11 ipv6 nd snooping trust
Command:
ipv6 nd snooping trust
no ipv6 nd snooping trust
Function:
Set the trust port of the switch.
Parameter:
None.
Command mode:
Port Mode.
Default:
un-trusted port.
Usage Guide:
This command sets a port or a group of ports as the trust port and deletes all dynamic binding
corresponding with the port or ports, stop creating new binding of port or ports, and accessing of
packets is also allowed.
Example:
Set a port or a group of ports as the trust ports.
Switch(config)#interface ethernet 1
Swithc(config-if-ethernet1/1)# ipv6 nd snooping trust
23.12 ipv6 nd snooping user-control
Command:
ipv6 nd snooping user-control
no ipv6 nd snooping user-control
Function:
Enable the control function of the ports for ND Snooping.
Parameter:
None.
Command mode:
Port Mode.
Default:
Disable the control function of ND Snooping.
Usage Guide:
After the control function of ND Snooping is disabled, clear all FFP drive entries which are sent by
ND Snooping for this port, but the binding information is not deleted.