PLANET XGS3-24040 - Manual (Page 227)

14-93
Switch(Config-If-Ethernet1/1)#priority-queue out
14.9 queue bandwidth
Command:
queue-bandwidth
no queue-bandwidth
Function:
Configure the bandwidth pledge for the egress queue.
Parameter:
is the queen ID to configure the bandwidth pledge, the different chip supports the
different queue count, the range is difference too, the normal state is 8 queue, and the ranging from
1 to 8. is the min-bandwidth, ranging from 0 to 128000, when input 0, it
means the min-bandwidth function is not take effect. is the
max-bandwidth, ranging from 0 to 128000, when input 0, it means the max-bandwidth function is not
take effect. But the min-bandwidth and max-bandwidth are not allowed to input 0 at the same time,
and the min-bandwidth must not bigger than max-bandwidth.
Default:
The queue bandwidth have no pledge by default.
Command mode:
Interface Mode
Usage Guide:
The min-bandwidth pledge and max-bandwidth limit can be configured at the different or same
queue. For example: the queue1 bandwidth of ethernet1/2 is limited as 128kbps, it just need to
configure queue-bandwidth 1 0 128.
The queue bandwidth pledge for egress is relative to remove mode, for example: one port is the
strict priority-queue, the highest priority is queue 1 now, it will satisfy this queue traffic when block is
happened. But if user want the lower priority of queue having bandwidth, it can remain bandwidth via
this command, the lower priority queue’s min-bandwidth will be satisfied at first, then the excess
bandwidth is removed according to PQ.
Example:
Configure the min-bandwidth is 64kbps and the max-bandwidth is 128kbps for ethernet1/2 queue1.
Switch(config)#interface ethernet 1/2
Switch(Config-If-Ethernet1/2)#queue-bandwidth 1 64 128