PLANET XGS3-24040 - Manual (Page 277)

17-35
when configuring 6to4 tunnel relay. This relay IPv4 address will only be used when the packet uses
default route with a destination address not starting with a prefix of 2002.
Examples:
Configure the 6to4 tunnel relay IPv4 address as 178.99.156.8.
Switch (Config-if-Tunnel1)#tunnel 6to4-relay 178.99.156.8
17.2.42 tunnel mode
Command:
tunnel mode ipv6ip [ 6to4 | isatap]
no tunnel mode ipv6ip [ 6to4 | isatap]
Function:
Configure Tunnel Mode.
Parameter:
None.
Command Mode:
Tunnel Configuration Mode.
Default:
None.
Usage Guide:
In configuring tunnel mode, only specifying ipv6ip indicates configuring tunnel. Ipv6ip 6to4 indicates
it is 6to4 tunnel, ipv6ip isatap indicates it is ISATAP tunnel.
Example:
Configure tunnel mode.
1、Switch(Config-if-Tunnel1)#tunnel mode ipv6ip
2、Switch(Config-if-Tunnel1)#tunnel mode ipv6ip 6to4
3、Switch(Config-if-Tunnel1)#tunnel mode ipv6ip isatap