PLANET XGS3-24040 - Manual (Page 785)

47-3
Parameters: None.
Command Mode: Admin Mode.
Usage Guide: By enabling the debug information of AAA about connection details, users can check
connection details of AAA, which might help diagnose the cause of faults if there is any.
Example: Enable the debug information of AAA about connection details.
Switch#debug aaa detail connection
47.7 debug aaa detail event
Command: debug aaa detail event
no debug detail event
Function: Enable the debug information of AAA about events; the no operation of this command will
disable that debug information.
Parameters: None.
Command Mode: Admin Mode.
Usage Guide: By enabling the debug information of AAA about events, users can check the information
of all kinds of event generated in the operation process of Radius protocol, which might help diagnose
the cause of faults if there is any.
Example: Enable the debug information of AAA about events.
Switch#debug aaa detail event
47.8 debug aaa error
Command: debug aaa error
no debug error
Function: Enable the debug information of AAA about errors; the no operation of this command will
disable that debug information.
Parameters: None.
Command Mode: Admin Mode.
Usage Guide: By enabling the debug information of AAA about errors, users can check the information
of all kinds of errors that occurs in the operation process of Radius protocol, which might help diagnose
the cause of faults if there is any.
Example: Enable the debug information of AAA about errors.
Switch#debug aaa error
47.9 radius nas-ipv4
Command: radius nas-ipv4 <ip-address>
no radius nas-ipv4
Function: Configure the source IP address for RADIUS packet sent by the switch. The “no radius
nas-ipv4” command deletes the configuration.
Parameter: is the source IP address of the RADIUS packet, in dotted decimal notation, it
must be a valid unicast IP address.